SD-WAN OMP VPN Route Status Codes

When creating an SD-WAN service VPN using the Overlay Management Protocol (OMP), the show omp routes command indicates the status of the routes received for a particular VPN. An example output is shown here:

vEdge# show omp routes
---------------------------------------------------
omp route entries for vpn 1 route 10.2.2.0/24
---------------------------------------------------
            RECEIVED FROM:
peer            0.0.0.0
path-id         70
label           1005
status          C,Red,R
loss-reason     not set
lost-to-peer    not set
lost-to-path-id not set
    Attributes:
     originator       172.16.255.11
     type             installed
     tloc             172.16.255.11, lte, ipsec
     ultimate-tloc    not set
     domain-id        not set
     overlay-id       1
     site-id          100
     region-id        None
     region-path      65534
     preference       not set
     tag              not set
     origin-proto     connected
     origin-metric    0
     as-path          not set
     community        not set
     unknown-attr-len not set

Within this output, as shown, there is a status indicator. This indicator can have any of the following codes:

C   -> chosen
I   -> installed
Red -> redistributed
Rej -> rejected
L   -> looped
R   -> resolved
S   -> stale
Ext -> extranet
Inv -> invalid
Stg -> staged
IA  -> On-demand inactive
U   -> TLOC unresolved

https://networklessons.com/cisco/cisco-sd-wan/cisco-sd-wan-service-vpn